Hitachi DV-C605U Service Manual page 46

4-4-3 Bracket Worm Ass'y Removal
1) Disconnect LCN02 Œ from Sensor PCB ´.
2) Push the 4 Hooks ˇ in direction of arrow and remove the Sensor PCB ´.
3) Remove 2 Screws ¨ and lift up the Bracket Worm Ass'y ˆ.
4) Remove Belt Ø.
5) Remove Washer ∏ and the Gear Roulette ".
6) Remove 2 Screws ' and the Shaft Worm Ass'y ˝.
7) Remove 2 Screws Ô and the Worm Motor .
ˆ BRACKET WORM ASS'Y
ˇ HOOK ˇ HOOK
´ SENSOR PCB
Ø BELT
˝ SHAFT WORM ASS'Y
Ô 2 SCREWS
 WORM MOTOR
ˇ HOOK
ΠLCN02
ˇ HOOK
ˇ HOOK
<Bottom View>
Fig. 4-11 Bracket Worm Ass'y Removal
¨ 2 SCREWS
∏ WASHER
" GEAR ROULETTE
' 2 SCREWS
´ SENSOR PCB
Disassembly and Reaasembly
4-11