Crown CT13588V Original Instructions Manual page 16

Symbol
Power tool designation
Orbital sander machines are designed for dry grinding
of various materials�
Power tool components
1 Oscillation rate regulator
2 Ventilation slots
3 On / off switch
4 Port for dust removal
5 Sanding plate
6 Sanding sheet holder
7 Dust-collecting container (assembly) *
8 Sanding sheet *
Meaning
Movement direction�
Rotation direction�
Locked�
Unlocked�
Prohibited�
Double insulation / protec-
tion class�
Attention� Important�
A sign certifying that the
product complies with es-
sential requirements of the
EU directives and harmo-
nized EU standards�
During operation, remove
the accumulated dust�
Useful information�
Do not dispose of the power
tool in a domestic waste
container�
9 Cover of the dust-collecting container *
10 Body of the dust-collecting container *
11 Filter *
* Optional extra
Not all of the accessories illustrated or described
are included as standard delivery.
Installation and regulation of power tool
elements
Before carrying out any works on the power tool it
must be disconnected from the mains.
Mounting / replacement of sanding sheet (see fig. 1)
Prior to mounting on the sanding sheet 8,
ensure that the given sanding sheet is
suitable for the specific power tool model
(proper dimensions and dust removal ap-
ertures are present).
• Position the power tool so that sanding plate 5 is
pointed upwards�
• Loosen the holders 6 as shown in figure 1.1.
• In case of replacement remove the worn out abra-
sive paper 8�
• Put new sanding sheet 8 to sanding plate 5 (see
fig. 1.2). Follow the rules below:
• abrasive sputter of the paper 8 should be on
the top side (the paper 8 should touch the grinding
plate 5 with the smooth side);
• apertures in sanding sheet 8 must match the dust
removal apertures on sanding plate 5�
• Bend the edges of the abrasive paper 8 so that they
are situated under the holders 6 (see fig. 1.3).
• Fix one edge of the abrasive paper 8 with the hold-
er 6, and then pull the other edge and fix it with the
other holder 6 (see fig. 1.4).
Caution: the abrasive paper 8 should be
pressed tight to the grinding plate 5, and
dust extraction holes of the abrasive pa-
per 8 and the grinding plate 5 should fit
together.
Mounting / dismounting of the dust-collecting con-
tainer (see fig. 2)
• During assembly put the dust-collecting container 7
onto a dust removing port 4 (see fig. 2.1).
• During disassembly take the dust-collecting con-
tainer 7 off from the dust removing port 4 (see fig. 2.2).
Emptying the dust-collecting container (see fig. 3)
Monitor the dust-collecting container 7
filling, and empty it promptly according
to safety precautions described above.
• Turn off the power tool and take off the dust-collect-
ing container 7 as described above�
• Press on two holding locks on the cover 9 and take
the cover 9 off (see fig. 3.1).
• Observing safety regulations, dump the container
body 10 contents out; for better results, clean the inner
surfaces of the body 10 and cover 9 with a soft brush
(see fig. 3.2-3.3). Clean filter 11 with soft brush or blow
English
16