Table of Contents
Advertisement
If soaking then the ST535 will advance to the next segment if any,
or else it will end the firing.
Changes made to the operation of the ST535 in this way are
temporary and are not stored.
Program Pause Facility:
While firing press and hold down the fn key then press the
obtain the pause function.
The ST535 will sound a short beep and the executing program will
pause at the current kiln temperature. The pause indicator (||) will
light. To release the pause repeat the above action
WARNING - PROGRAM PAUSE
The program pause facility should be used with care. Program
execution is suspended and the kiln will be held at its current
temperature. If left too long at high temperatures kiln damage
could result. Pause will automatically release after an Installer-
defined time period (default: 2 hours - see Installation Handbook).
Energy consumption
While a program is running you can check the energy consumed up
to this point of firing.
When Main display shows the current temperature push
once. Main display will show the current set point temperature
Set Point temperature
While a program is running you can check the set point
temperature (the temperature which the ST215 is currently trying
to achieve).
When Main display shows the current temperature push ◄ key
twice. Main display will show the current set point temperature
6.11 Program STOP
To stop the firing prematurely at any time press the
The firing indicator lamp will go out.
While paused, the kiln temperature display will
alternate periodically with a scrolling PAUSED
PAUSED display and a beep will be sounded.
25
▼
key to
◄ key
▶
key .
Advertisement
Table of Contents
