When END is displayed, to exit program data entry push
The display shows the current kiln temperature.
No indicators lit on the mimic panel and the run indicator is off
Note 1: to exit programming without cycling through all of the
above steps wait 10 seconds without pressing any keys - the ST215
will revert to the idle display.
Alternatively press the
firing immediately
Note 2: the
key can be used to reverse through the
◄
programming steps to correct errors or to exit programming
mode.
Note 3: If the controller remains idle for 10sec it will autonatically
exit the programming mode. Any changes made are automatically
saved.
6.7 Altering, Reviewing a program
To Alter/ Review a program we follow the same procedure as
entering a new program.
6.8 Program Start
To start a program press the
displayed push
At this point, you can program your kiln to start firing at a future
time, when you will not be in your studio to start a firing.
▶
key to exit programming and to begin
►
A program number will be displayed.
The required firing program can now be
selected with the
When
the
▶
to start
Display will show program start
delay time
key.
▲
▼
&
desired
program number
22
►
key.
.
keys
is