Logic Sensor Ii; Adjustment; Warn Away Sensitivity - Clarion UNGO MS5500 Install Manual

Logic Sensor II

Because of its advanced design, the Logic Sensor II can be set for Shock and Motion
detection or Shock detection only.
Sensitivity jumper is set determines if motion is detected. See Mounting Components and
Jumper Selections.

Adjustment

The shock sensitivity of the Logic Sensor II is set using the Remote Transmitter. There are 12
levels of sensitivity.
• If the sensitivity is set to Level 1, the Logic Sensor II is off.
When the sensitivity is set to Level 1, the siren will emit 1 chirp, followed by 3 chirps each time the system is
Armed to indicate that the Logic Sensor II is off.
Level
To Adjust the sensitivity:
1. Turn the ignition key on.
2. Within 4 seconds, press Transmitter Button 1.
• The siren will chirp (1 through 12) to indicate the current sensitivity level. The
default shock sensitivity setting is 6.
3. Test the sensitivity. The siren will respond with a short chirp when shock or motion is
detected.
Be sure that the Logic Sensor II is mounted horizontally if motion detection is desired.
4. To make adjustments:
Press Button 1 to increase the sensitivity.
Press Button 2 to decrease the sensitivity.
• The siren will chirp to indicate the sensitivity level each time the Button is pressed.
5. When you are satisfied with the sensitivity, turn off the ignition.
Motion Sensitivity
The motion sensitivity of the Logic Sensor II can be fine-tuned through internal jumper
selection. There are two settings for motion sensitivity, High and Low. The default setting
is Low. To change to setting the setting, see Jumper Selections.

Warn Away Sensitivity

The sensitivity of the Logic Sensor II's Light Impact Response can also be adjusted. There
are two settings for Warn Away, High and Low. The default setting is High. To change the
setting, see Programming.
Page 20 - MS5500 Installation Manual
Logic Sensor II Sensitivity
1 2
off lowest
The way the sensor is mounted and the Motion
12
highest