Quick Reference Guide - Clarion Ungo S100 Owner's Manual

QUICK REFERENCE GUIDE

To arm using your remote
You can activate, or arm, the system by pressing
second. When the system arms, you will hear a short siren sound, or chirp, and
the parking lights will flash once. If the vehicle's power door locks have been
connected to the system, the doors will lock.
To disarm using your remote
To disarm the system, press
will flash twice. If power locks are connected to the system, the doors will unlock.
If the siren chirps either four or five times when disarming, see Diagnostics
section. This is called notification of system alarming in your absence.
Arming while driving
Press on your remote for two second while the vehicle is running. The
system will chirp once and then once more to indicate that the ignition is on.
Disarming without a remote
Turn on the ignition. Press the Override switch the programmed number of
times within 15 seconds. After five seconds, the system will disarm. If it does
not, you may have waited too long. Turn the ignition off and on and try again.
To enter or exit valet mode
Turn ignition to RUN position, then turn to OFF position. Press and release
the Override switch within 10 seconds. The status LED will light solid if you
are entering valet mode, and it will go out if you are exiting valet mode.
To activate Panic Mode
Press and hold down for one second.
To exit Panic Mode
Press on the remote.
To activate Silent Arm/Disarm
Press briefly before arming or disarming, and the confirmation chirp(s)
will be eliminated for that one operation only.
Location of Override switch_______________________________
Number of Override switch pulses for disarming_____________
on your remote for one
. You will hear two chirps, and the parking lights
31