Fisher & Paykel WL4027P1 Solving Operating Problems

Solving Operating Problems

Pressing POWER Does Not Turn ON Washer

• Is the power switched on at the wall?
• Unplug from wall. Wait 60 seconds, plug back in, turn on and try again.
• Could household power supply be at fault? Try plugging in another appliance in the same power socket.
• Keylock mode may be activated. Try holding down the POWER button for 3 seconds (refer to page 18).

Pressing START/PAUSE Does Not Start the Fill

• Are both hot and cold faucets turned on?
• Are the inlet hose filters blocked? Check both ends of the hoses.
• Is DELAY START set? (selected models only).

Filling Continuously

• Ensure drain hose is located in the standpipe or tub / sink.
• Ensure standpipe or tub / sink is at least 33 1⁄2" (850 mm) high but no more than 95" (2413 mm) high.
• Check that the washer is not siphoning (refer to page 9).

Not Spinning Properly

• Ensure load is not out of balance.
• Check washer is level and does not rock in any direction.
• Ensure washer does not have suds build up.
• Check that the washer is not siphoning (refer to page 9).

Spin Speed Sounds Slower than Normal

• Clothes are unevenly distributed in the wash basket, your washer has slowed the spin to compensate.
https://producthelp.fisherpaykel.com/us/Wash/Top_Loaders/AquaSmart/WL4027P1/User_Guide_WL4027P1/19_solving_oper...
Updated: Tue, 16 Nov 2021 11:38:57 GMT
Powered by
1