Setting Up The Projector - InFocus LP130 User Manual

SETTING UP THE PROJECTOR

1 Place the projector on a flat surface.
The projector must be within 10 feet (3 m) of your power
•
source and within 6 feet (1.8 m) of your computer.
If you want to project from behind a translucent screen, set
•
up the projector behind your screen. See "Rear Projection"
on page 23 to reverse the image.
2 Position the projector the desired distance from the screen.
If the image is too big or too small, use the zoom ring to
•
adjust the size or move the projector forward or backward.
Figure 3 shows three projected image sizes. For more infor-
mation about image size, see "Projected Image Size" on
page 46.
3 Make sure the projector and the computer are turned off.
20 ft.
12 ft.
5 ft.
Projected image size at minimum zoom
F 3
IGURE
5