Electrical And Internet Hookup - Nuvve EVSE-B-P Series Installation And Setup

ELECTRICAL AND INTERNET HOOKUP

• Install conduit (as required) for the power and internet connections. You may use the
knockouts provided on the bottom (as shown) or the back of the case.
• The internet connection requires connection to a building router; the internet cable
should have an RJ45 connection attached, to be plugged into the top of the red circuit
board (see blue cable in diagram).
• Some jurisdictions require that the ethernet cable be routed in separate conduit
available at the back or bottom. For interior wiring, it may be acceptable to run ethernet
cable wire-tied outside of the power conduit.
• If no wired internet connection is available, ask for Nuvve's instructions for mounting a
Wi-Fi transceiver next to the PowerPort, to provide internet via existing Wi-Fi in a nearby
room, building or parking lot. Nuvve can provide documentation and instructions, but
the Wi-Fi device is provided and supported by a third party.
• Next, follow either "Single Phase" or "Three Phase" sections, as appropriate.
Page 9 | Doc #: NU-000032-A, PowerPort Installation & Setup