Powerport Installation And Setup; Safety Information And Overview; Supplied Components In Package; Unpacking - Nuvve EVSE-B-P Series Installation And Setup

SAFETY INFORMATION AND OVERVIEW

WARNING – When using electric products, basic precautions should always be followed,
including the following. This manual contains important instructions for Models EVSE-B-PX-
TXX-HX-AXXX that shall be followed during installation, operation and maintenance of the
unit.
a) Read all the instructions before using this product.
b) This device should be supervised when used around children.
c) Do not put fingers into the electric vehicle connector.
d) Do not use this product if the flexible power cord or EV cable is frayed, has broken
insulation, or any other signs of damage.
e) Do not use this product if the enclosure or the EV connector is broken, cracked, open, or
shows any other indication of damage.
Critical setting: PowerPort has an internal setting to limit the EV's current drawn. The
installing electrician must set this properly to not exceed the rating of the building circuit
and the installed connector. See section "Critical Setting: Current Limit."
Critical Setting: Torque of connectors on the supply connection to the Nuvve PowerPort
must follow recommended torque. See section on Electrical and internet hookup.
Follow all applicable safety standards, building codes, and electrical codes. In the US, see
NEC 625. This unit provides ground fault circuit protection. The circuit breaker feeding this
unit should not have ground fault protection. Adapters, conversion adapters, and extension
cords are not allowed to be used with this equipment.
Always use proper lockout and tag out precautions and comply with all national and
local codes. Please review these instructions carefully before you begin the installation.

SUPPLIED COMPONENTS IN PACKAGE

• EVSE-B with cable and hanger attached
• PowerPort Installation and Setup Manual. (This document)
• User Quick Start sheet
Note: Please check SUPPORT.NUVVE.COM for document updates prior to attempted
installation.

UNPACKING

• Unpack the shipping carton
• Remove the three Torx 25 bolts holding on the cover
• Remove the cover by sliding it up, towards the top of the unit
• Unplug the front panel display flex/ribbon cable from the board
• Unscrew the ¼ inch nut and washer holding the ground strap to the cover and retain
nut and washer for reinstallation later
• Place back cover flat, and place top cover to side as shown in figure, being careful not to
scratch the paint.
Page 4 | Doc #: NU-000032-A, PowerPort Installation & Setup