Nuvve EVSE-B-P Series Installation And Setup page 14

3. If the blue "Internet" light is not steadily on: If the blue bulb is dark, the EVSE is not
connected to the internet in the building, so, check the internet cable going from the
EVSE to the building router, and check operation of the internet connection. If the blue
bulb is blinking, the internet is connected but the server is not responding. The user can
contact Nuvve, or simply check again to see if the server has recovered; if not, request
technical support.
4. If the red "Error" light is blinking. (It is normal to blink 30 seconds when power is first
connected.) If error light blinks during charging, charging will stop, and it is permissible
to retry by unplugging and replugging the cord-set from the vehicle inlet. If allowed
in your jurisdiction the unit may automatically retry several times. Blinking means a
"ground fault" which often is simply caused by moisture on or in the connector; if damp,
try removing and cleaning out the connector, or if time allows, leave it to dry out in the
air, then retry. If these do not fix the blinking red light, a qualified service person should
be consulted.
5. Red "Error" light is continuously on. Red light staying on means that the EV has tried
to draw more current than is permitted. If this occurs the first time the EVSE is used, or
the first time a high-current-load car is used, it could be a problem with configuration
settings of the EVSE. Otherwise, this may be due to a problem with the car drawing
more than is permitted.
6. If the red error light persists on or persists blinking when not plugged into a car, do not
use the EVSE. The unit must be serviced prior to any further use.
Moving and storage:
An installed PowerPort is directly connected to the electric system and should be removed
only by a qualified electrician. Care should be taken to protect the unit from physical and
cosmetic damage when moving or storing the unit. The unit should be kept dry during
storage.
Page 14 | Doc #: NU-000032-A, PowerPort Installation & Setup