I S TECHNOLOGY SOLUTIONS BRAKE PRO S-4027 Operating Manual page 31

Automatic single car testing device for freight cars
Table of Contents

Advertisement

I S TECHNOLOGY SOLUTIONS
to ensure that its conditions of accuracy and adjustment remain substantially comparable to
the condition as originally shipped by IS TECHNOLOGY SOLUTIONS.
6. I S TECHNOLOGY SOLUTIONS warrants that the intellectual contribution made to the system
(commonly referred to as "software") fairly tests said brake equipment and evaluates it to the
standards published by the entities listed above in paragraph 2. If any findings to the contrary
are found within three years from delivery by the Buyer, then I S TECHNOLOGY SOLUTIONS
will correct or replace the defective section or part at no further cost to Buyer. In the case of
software found defective or incorrect, I S TECHNOLOGY SOLUTIONS shall deliver to buyer
within a reasonable time, a corrected section of the software to the place where it will be used,
and provide instructions for its installation and use.
7. If any mechanical or electrical part or component is found to be defective because of
manufacture or design within one year from date of shipment by I S TECHNOLOGY
SOLUTIONS, then I S TECHNOLOGY SOLUTIONS agrees to provide repair or replacement
of said part at no cost to buyer. This is offered even though some of the original manufacturers
of parts and components might have lesser warranty terms. Abuse or negligent handling or
exposure to climatic extremes may void this section of the warranty. Expendable parts, such
as gaskets, fuses, handles, knobs and other vulnerable components are exempted from this
warranty.
8. The period between the end of the first and third years shall be called "The First Extended
Warranty Period" or FEW Period. Failure of any component or part during this period from
normal wear and tear shall be covered by the terms of FEW, as follows. "Parts or components
that fail to perform during FEW are subject to repair or replacement by I S TECHNOLOGY
SOLUTIONS on a pro rata basis. The FEW period has a duration of 24 months, and any part
that fails in month 1 shall be repaired or replaced for 10% of the value of a new part, and pro-
rata through the period, until one day before the end of month 24, shall be repaired or replaced
for 90% of current new value. The repairs or replacement shall be done at I S TECHNOLOGY
SOLUTIONS' facilities f.o.b I S TECHNOLOGY SOLUTIONS facility.
9. I S TECHNOLOGY SOLUTIONS cannot accept claims for consequential loss or damage. Our
liability is limited to the value of the property or part thereof as explained herein.
10. The foregoing states our full liability and no employee or officer of I S TECHNOLOGY
SOLUTIONS is authorized to modify or amend this policy, except for a general letter to all
customers, signed by a principal officer of I S TECHNOLOGY SOLUTIONS.
11. The warranty terms and obligations stated herein are valid only if payment for the device at
the time the claim is made is not delinquent as defined in I S TECHNOLOGY SOLUTIONS
quotations and invoices. If the quotation and invoice are at variance, the invoice will be
considered the applicable document.
31

Advertisement

Table of Contents
loading

This manual is also suitable for:

Brake pro

Table of Contents