Turn On The Projector - InFocus Learn Big IN3102 Quick Start Manual

4
Turn on projector and source
5-10 sec.
source
1
Connect the power cord to the projector
and to an electrical outlet
The power light
2
Remove the lens cap
3

Turn on the projector

Touch the power light (or press power on the remote).
The power light will start blinking green.
4
Wait for the lamp to warm up
After a few seconds, the power light will stop blinking, and the
other buttons on the keypad will light up. It can take a minute
for the lamp to reach full brightness.
Warning: Do not look directly into the lens
when the projector is turned on.
5
Turn on computer or other source
If your computer is connected to the DisplayLink connector,
follow the instructions on your computer's screen. Otherwise,
you may need to press a specific key combination to activate
your laptop's external video port. On most laptops, hold down
the FN key while pressing a key labeled CRT/LCD, LCD/VGA, a
monitor icon
Apple F7
Dell Fn+F8
Fujitsu Fn+F10
Complete laptop activation chart at www.infocus.com/support
Important: If there is still no video, restart your
i i
computer (first make sure it's connected to the
projector and the projector is turned on).
6
Change source if needed
If needed, press source (on the projector or remote) to view the
source. You may have to press it more than once.
on the projector will light amber.
, or similar. Key combos for popular models:
Gateway Fn+F3 or Fn+F4
HP/Compaq Fn+F4 or Fn+F6
Sony Fn+F7
Turn over
IBM ThinkPad Fn+F7
Toshiba Fn+F5