Assembly Instructions - Prinetti IA5007A Instruction Manual

Assembly Instructions

NOTE: The Fan can be used only when completely and correctly assembled, that is
complete with its base and support.
1. Remove all parts of the Fan from the gift box and lay out in front of you.
2. The body of the Fan comes pre-assembled and does not require any further
assembly.
3. Gently place the Fan face down on a flat surface with the bottom facing toward
you. Unscrew the base nut from the short threaded shaft and slide it down the
power cable away from the bottom of the Fan.
4. Fit the front or rear base piece
to the bottom of the Fan body
by aligning the centre hole in
the base piece with the short
threaded shaft of the Fan body.
5. Slowly rotate the base piece until
the locating lug on the Fan body
aligns with the small hole in the
Fan base piece.
6. Fit the second base piece following steps 4 and 5, ensuring that the male and
female alignment pins near the outer edges of the base pieces fit snugly together.
7. Gently push and lock the base pieces together using the locking tabs located
between each of the alignment pins on both base pieces. Gently squeeze the
tabs until they open and push the base piece firmly together so that the locking
tab secures the base pieces together. Repeat for both locking tabs.
8. Slide the base nut along the power cable until it reaches the threaded shaft on
the bottom of the Fan body.
9. Tighten the nut onto the threaded shaft. This will secure the base to the Fan body.
10. Loop the power cord through the three slots found on the under side of the base.
Then slot the power cord into the groove found in the side of the base. If the power
cord is not slotted correctly into the side groove, the base will become unstable.
NOTE: Do not over tighten the base nut onto the Fan body. Do not use tools only
your fingers to adjust the nut.
CAUTION: Do not use the Fan with the base resting on the power cable. The cable
must be passed through the slots found on the under side of the base.
AFTER SALES SUPPORT AU 1300 777 137 NZ
0800 824 556 service@unclebills.com.au
07