Prinetti IA5007A Instruction Manual page 9

Operating Instructions (cont.)
• To turn the Fan off, press the OFF button on the control panel.
To use the remote control to power the Fan on or off, follow the above directions and
use the corresponding buttons on the remote control.
Speed Selection
• To alter the speed of the Fan, press the SPEED/ON button repeatedly to cycle
through the low (Lo), medium (Me) and high (Hi) speed settings.
Lo
• The LED indicator panel will illuminate the corresponding selected speed with a
red indicator light.
To use the remote control to alter the speed of the Fan, follow the above directions
and use the corresponding buttons on the remote control.
Oscillation Function
The Fan has an oscillation function that allows it to circulate air throughout the room.
Press the OSC button on the control panel, and the Fan will begin to rotate left and
right automatically. To stop the oscillation at any point, press the OSC button again.
To use the remote control to activate the oscillation function, follow the above
directions and use the corresponding buttons on the remote control.
Timer Operation
The Fan has a timer that allows the user to program the Fan to run for a period of time
then automatically switch off.
The timer can be programmed from 0.5 hours up to a maximum of 7.5 hours, and is
programmable in 0.5 hour increments.
To program the timer follow the steps below:
3. Press the TIMER button on the control panel.
4. The timer will activate, and the 0.5 indicator light will illuminate on the LED
indicator panel.
AFTER SALES SUPPORT AU
Me
1300 777 137 NZ
0800 824 556
Hi
service@unclebills.com.au
09