Advertisement
Assembly Instructions
NOTE: The Fan can be used only when completely and correctly assembled, that
is complete with its base, support and protection grilles.
Assembling the Stand
1. Make a cross with the cross bases (20) by fitting them together at the center.
Then fit the 4 end caps (21) to the ends of the cross bases.
2. Attach the base tube (17) to the base.
3. Align the four holes in the bottom of the base tube with the four holes in the
cross base.
4. Insert the four base screws (19) into the aligned holes and tighten them
completely.
5. Turn the height adjustment ring (16) and remove it.
6. Slide the base cover (18) down so that it covers the screw tops in the cross
base.
7. Replace the height adjustment ring (16) but do not tighten.
8. Extend the extension pole (15) and secure it by tightening the height
adjustment ring (16).
NOTE: If the extension pole is not readily visible, look inside the base tube (where
it is located) and extend it completely.
9. Attach the control panel (13) with the motor housing (11) assembly to the top
of the extension pole (15).
10. Tighten the adjustment screw at the rear of the control panel to fix the control
panel and motor assembly onto the extension pole (15).
AFTER SALES SUPPORT AU
1300 777 137 NZ
0800 824 556
service@unclebills.com.au
07
Advertisement
