Table of Contents
Advertisement
Before installing this card carefully read the Address Selection and Option Selection sections of
this manual and configure the card according to your requirements. Be especially careful with
address selection. If the addresses of two installed functions overlap, you will experience
unpredictable computer behavior.
To install the card:
1. Remove power from the computer.
2. Remove the computer cover.
3. Remove the blank I/O backplate if you are going to
make I/O connections to this prototype card.
4. Select the base address of the card. (See Address
Selection section of this manual.)
5. Install jumpers for selection as either an I/O card or as a Memory card. (See Option
Selection section of this manual.)
6. Install the card in an expansion slot.
7. Inspect for proper fit of the card and cables and tighten screws.
8. Replace the computer cover.
MANUAL 00650-100-10
CHAPTER 1
INSTALLATION
Page 1
Advertisement
Table of Contents
