Table of Contents
Advertisement
Computer Connector:
Breadboard Area:
Address Signals:
Data Signals:
Address Decode:
Card Address Block:
Output Connector:
Bracket:
Card Size:
Operating Temperature:
Storage Temperature:
Humidity:
MANUAL 00650-100-10
CHAPTER 5
SPECIFICATIONS
Gold edge connector for IBM PC/XT,PC/AT, or compatible
computers.
Approximately 35 square inches with 0.035" plated-through holes
spaced 0.100" apart. Heavy ground and +5VDC buses surround
the breadboard area.
Address lines are buffered by type 74LS244 line drivers, labeled,
and available at assigned pads. See Schematic.
Data lines D0 through D15 are buffered by two type 74LS245
transceiver, and are available at assigned pads. See Schematic.
Decoding provided for either I/O addresses or for Memory
addresses. Card address is DIP switch selectable.
Jumper selectable; 8, 16, or 32 bytes for I/O card use and 32K,
64K,128K, or 256K for Memory card use.
A 37-pin Sub-D right angle connector and mounting bracket are
included.
Properly spaced holes are provided for other
combinations of connectors such as 9-pin Sub-D plus 25-pin Sub-
D. The card will also accept 50-pin ribbon cable connectors.
Mounting bracket for standard 37-pin Sub-D connector included.
Full size PC/XT card (13.25" x 3.87")
0 to +60
C.
o
-20 to +85
C.
o
5% to 95% RH, non-condensing.
Page 13
Advertisement
Table of Contents
