Citizen CLP 1001 User Manual page 13

thermal or thermal transfer printing, tear mode, etc.
To enter the printer setup mode, press and hold down the Pause key then press
the Feed key and release both keys. The functions of the control keys are
described below.
Changes to the printer configuration are stored in "nonvolatile memory". This
guarantees that the printer configuration is maintained even after the power is
turned off.
n Pause key:
Selects the mode.
n Feed key:
Selects the mode item.
n Stop key: Saves the selection contents and returns the printer to the
normal operating mode.
The functions indicated by an ♦ character work on the CLP 1001, 2001, 6001, 6002
and 6401 printers. Those with a ● character work on the CLP 7201e and 7202e
printers
LCD Indication
♦●
Transfer DirectTM
♦
Peel OFF Peel ON
♦
Cut OFF Cut ON
♦
Tear OFF Tear ON
●
AfterPrt PeelWait
TearBar
♦●
Edge Reflect
●
HeadHeat Heat 01
●
PrintSpd PSpeed 2
●
Feed Spd FSpeed 2
●
BSpeed 2
Back Spd
●
V-2.00in
Vert Adj
● H-2.00in
HorizAdj
●
S-2.00in
StopPos
●
SetLckON
SetLckOF
Function Description
Direct thermal or thermal transfer
printing
Enable or disable peeler function
Enable or disable cutter function
Enable or disable tear-off function
"AfterPrint" functions. Set the
AutoCut
operation of the printer after the
NoAction
label has been printed.
Select media gap detection method
ContinuP
either "edge" (label gap), reflective
or continuous media
Set the printhead temperature
Heat 30
Set the print speed in inches/second
PSpeed 7
Set the feed speed in inches/second
FSpeed 7
Set the back feed speed in inch/sec
BSpeed 7
Vertical label position adjustment.
V+2.00in
H+2.00in Horizontal label position adjustment.
Stop position adjustment
S+2.00in
Settings Lock Off/On. When "on",
causes the printer to ignore
commands changing the above
values set on the control panel.
E
N
G
L
I
S
H