Xantrex 883-0105-12 Quick Start Manual

Xantrex Lithium-ion Batteries Quickstart Guide
http://www.xantrex.com
883-0105-12
883-0125-12
883-0125-12-04
DANGER
HAZARD OF FIRE,ELECTRIC SHOCK,EXPLOSION,OR ARC FLASH
This Xantrex Lithium-ion Batteries Quickstart Guide is in addition to, and incorporates by reference, the relevant product manuals for each product
in the power system. After reviewing this guide you must read the relevant product manuals. Unless specified, information on safety,
specifications, installation, and operation is as shown in the primary documentation received with the product. Ensure you are familiar with that
information before proceeding.
Failureto followtheseinstructionswillresult in death orseriousinjury.
Exclusion for Documentation
UNLESS SPECIFICALLY AGREED TO IN WRITING, SELLER (A) MAKES NO WARRANTY AS TO THE ACCURACY, SUFFICIENCY OR
SUITABILITY OF ANY TECHNICAL OR OTHER INFORMATION PROVIDED IN ITS MANUALS OR OTHER DOCUMENTATION; (B)
ASSUMES NO RESPONSIBILITY OR LIABILITY FOR LOSSES, DAMAGES, COSTS OR EXPENSES, WHETHER SPECIAL, DIRECT,
INDIRECT, CONSEQUENTIAL OR INCIDENTAL, WHICH MIGHT ARISE OUT OF THE USE OF SUCH INFORMATION. THE USE OF ANY
SUCH INFORMATION WILL BE ENTIRELY AT THE USER'S RISK; AND (C) REMINDS YOU THAT IF THIS MANUAL IS IN ANY
LANGUAGE OTHER THAN ENGLISH, ALTHOUGH STEPS HAVE BEEN TAKEN TO MAINTAIN THE ACCURACY OF THE TRANSLATION,
THE ACCURACY CANNOT BE GUARANTEED. APPROVED CONTENT IS CONTAINED WITH THE ENGLISH LANGUAGE VERSION
WHICH IS POSTED AT HTTP://WWW.XANTREX.COM.
NOTE: Visit http://www.xantrex.com , click Products, select a Product category, select a Product, and search the Product Documents panel for a
translation of the English guide, if available.
Contact Information
Telephone: +1-800-670-0707 / +1-408-987-6030
Email: customerservice@xantrex.com,
http://www.xantrex.com/power-products-support/
Web: http://www.xantrex.com
2
IMPORTANT
ON FIRST USE: Perform a full charge, discharge, and charge cycle to ensure maximum
battery life. For information, see Battery Storage Guide on the reverse side of this document.
Introduction
The Xantrex Lithium-ion Batteries are lithium iron phosphate (LiFePO
used in conjunction with the internal Battery Management System (BMS) unit which protects
the batteries and monitors state-of-charge (SoC), voltage, current, and temperature.
c
BATTERY DISPOSAL
At the end of the battery's useful life, proper disposal is required. Do not dispose the
battery with ordinary household waste. Refer to your local codes for proper disposal of
lithium-ion batteries.
975-0827-01-01 Rev A
April 2021
1
Important Safety Information
READ AND SAVE THESE INSTRUCTIONS
Electrical equipment shall be installed, operated, serviced, and maintained only
by qualified personnel. Certain configuration tasks shall only be performed by
qualified personnel in consultation with your local utility and/or an authorized
dealer. Servicing of batteries and the BMS shall only be performed or
supervised by qualified personnel with knowledge of lithium-ion batteries and
their required precautions. Qualified personnel have training, knowledge, and
experience in:
• Installing electrical equipment
• Applying applicable installation codes
• Analyzing and reducing the hazards involved in performing electrical work
• Installing and configuring lithium-ion batteries
• Selecting and using Personal Protective Equipment (PPE)
No responsibility is assumed by Xantrex LLC for any consequences arising out
of the use of this material.
HAZARD OF FIRE, ELECTRIC SHOCK, EXPLOSION, BURN, OR ARC FLASH
• This battery shall be installed and serviced only by qualified personnel.
• Always wear proper PPE (safety glasses and clothing) when working on the Li-ion battery and follow
safe electrical work practices according to local codes.
• Do not wear metallic items such as watches or bracelets when working on the battery. Use insulated
tools to prevent accidental short circuit.
• Do not install the Li-ion battery module adjacent to any heat source. Keep away from sources of ignition.
• Do not install or operate any of the system devices in a compartment containing flammable materials or
in locations that require ignition-protected equipment.
Failure to follow these instructions will result in death or serious injury.
3
Installation
1. Check the battery and the battery cable (if included) for visible damage including
cracks, dents, chips, and deformations.
2. Select a location for the battery that is stable, clean, cool, dry, and well-ventilated.
3. Mount the battery in upright (terminals pointing up) or sideways (terminals pointing
to one side) position with safety labels still visible and away from heat sources.
4. Orient the devices so that the cables avoid sharp bends. Follow the bending radius
recommendation below. This applies to both the communication and battery cables.
) chemistry batteries
4
Optional: Connect the 4-pin connector cable and route the remote panel connectors as
required.
NOTE: Installation and maintenance shall only be performed by qualified personnel as
defined in Important Safety Information above. Contact Xantrex for information resources.
Copyright © 2021 Xantrex LLC. All Rights Reserved.
All trademarks are owned by Xantrex LLC and its affiliates.
HAZARD OF FIRE, ELECTRIC SHOCK, EXPLOSION, BURN, OR ARC FLASH
• No user-serviceable parts. Do not attempt to open or dismantle the Li-ion battery. If the battery module is
damaged, do not touch the corrosive electrolyte or powder, and consult your dealer.
• When the battery module is damaged, it can release harmful gases. Ensure the surrounding
environment is well-ventilated.
• In case battery content comes in contact with skin or eyes, immediately flush the affected area with large
amount of clean water and seek medical help.
• In case of fire, use only a Class ABC (dry chemical) or CO
dangerous extinguishing medium for energized equipment because of the risk of electric shock.
• Dispose of Li-ion batteries through a local recycling center. Do not mix batteries with other wastes
Contact your local recycling center for proper disposal information.
• Do not crush, puncture, drop, disassemble, or dispose of in fire.
ARC FLASH
Failure to follow these instructions will result in death or serious injury.
HAZARD
c An example of an arc flash event
could be a direct short circuit
caused by a metallic object such as HAZARD OF FIRE,ELECTRIC SHOCK,EXPLOSION,AND PERSONAL INJURY
a tool bridging between the positive
• Do not expose the Li-ion battery to rain, snow, or liquids of any type. Products are designed for indoor use
and negative of an energized circuit.
only.
• Always use proper lifting techniques when handling the battery module. Battery is heavy.
DANGER
• Do not step on the battery module enclosure.
• Do not charge the battery in ambient temperature below freezing.
• Do not disconnect the battery while it is being charged.
Failure to follow these instructions can result in death or serious injury.
RISK OF EQUIPMENT DAMAGE
• Do not allow the battery to be depleted.
• Charge the battery module with an approved charger. Contact Xantrex for details.
• Do not charge the battery above the recommended voltage.
Failureto followtheseinstructionscan result in damageto equipment and mayvoid thewarranty.
4
Specifications
Nominal Capacity
Nominal Voltage
Charging Voltage (max)
Float Voltage
Low Battery Cutoff Voltage
Recommended Charge Current
Max Charge Current (continuous)
Recommended Discharge Current
Max Discharge Current (continuous)
Max Pulse Discharge Current
Internal Impedance
Weight
Charging Temperature
Discharging Temperature
L x W x H
Cycle Life at 25C to 80% Capacity
DANGER
type fire extinguisher. Water can be a
2
WARNING
NOTICE
NOTE: Specifications are subject to change
without prior notice.
Feature
883-0105-12
105Ah
12.8V
14.6V
13.4V
10.0V
50A
100A
50A
100A
200A (3 sec)
3-4mΩ
26.5lbs (12Kg)
32 – 131 °F (0 – 55 °C)
-4 – 131 °F (-20 – 55 °C)
10.24 x 6.6 x 8.23 in
(260 x 168 x 209 mm)
2800 (0.5C, 100% DOD)
883-0125-12
883-0125-12-04
125Ah
12.8V
14.6V
13.4V
10.0V
62.5A
125A
62.5A
125A
200A (3 sec)
3-4mΩ
28lbs (12.7Kg)
13.1 x 6.8 x 8.7 in
(332 x 172 x 220 mm)
2500 (0.5C, 80% DOD)
1