ProMOTION EV1 User Manual page 10

Therapy unit
Hide thumbs Also See for EV1:
Table of Contents

Advertisement

ProMOTION EV1
USING YOUR PROMOTION EV1 DEVICE
Installing Therapy Unit
The Therapy Unit can be used on its own for the application of heating or
cooling. If you wish to use compression therapy too, the Therapy Unit should
be paired with the Pump Unit and Compression wrap. To do this:
1
Align the Therapy Unit with the cradle.
2
Locate the slot in the front of the Therapy Unit against the plastic spring,
and push the Therapy Unit forwards (see image below).
3
Lower the Therapy Unit down into the cradle.
Allow the spring to push back, locking the Therapy Unit in place.
Precautions
Check the Therapy Unit is secure by pulling it up and away from the cradle.
Do not obstruct the air inlet or exhaust at either end of the Therapy Unit.
P18
User Manual
ProMOTION EV1
USING YOUR PROMOTION EV1 DEVICE
Installing Pump Unit
The Pump Unit attaches to the Compression wrap via a simple bayonet fitting.
To attach it:
1
Align the Pump Unit with the port on the cradle. Align the pips on each
component (see image below).
2
Gently support the compression wrap under the bayonet
3
Start to rotate the Pump Unit clockwise. The bayonet will
begin to engage.
continues overleaf
P19
User Manual

Advertisement

Table of Contents
loading

Table of Contents