Transport; Disposal And Recycling; Troubleshooting - FERREX 25CC User Manual

Putting the equipment back into operation
Remove the spark plug.
1.
Quickly tug on the starter line to remove excess oil from the combustion
2.
chamber.
Clean the spark plug and check that the electrode gap is correct, or insert a new
3.
spark plug with the correct electrode gap.
Prepare the equipment for operation.
4.
Fill the fuel tank with the relevant mixture of fuel and oil.
5.
Top up the chain oil in the chain oil tank.
6.

Transport

To transport the equipment, empty the petrol tank. Clean coarse dirt off the equip-
ment with a brush or hand brush. Alway mount the chain protection cover (24) to the
guide bar (2).

Disposal and recycling

The equipment is supplied in packaging to prevent it from being damaged in transit.
The raw materials in this packaging can be reused or recycled. The equipment and
its accessories are made of various types of material, such as metal and plastic. Never
place defective equipment in your household refuse. The equipment should be tak-
en to a suitable collection center for proper disposal. If you do not know the wherea-
bouts of such a collection point, you should ask in your local council offices.

Troubleshooting

The table below contains a list of fault symptoms and explains what you can do to
remedy the problem if your equipment fails to work properly. If the problem still
persists after working through the list, please contact your nearest service
workshop.
m IMPORTANT!
Hint in case of sending the equipment to a service centre:
Due to safety reasons please see to it that the equipment is sent back free of oil and
petrol!
Storage/Transport/Disposal and recycling/Troubleshooting Kapitelüberschrift
51