Table of Contents
Advertisement
4.5
Screen Control Codes (Cont.)
[A
(RS) = High for the following Control Codes]
0
36h
38h
39h
3Ch
3Dh
37h
3Ah
3Bh
*
Industrial Electronic Engineers, Inc.
Van Nuys, California
04/10/02
Erase Line Data With End Blink
Erases 1 or more lines of data (with blink) using a 2 byte command consisting of control code 36h
and blink field/line data.
Bits 0 through 3 retain (0) or erase (1) lines 0 through 3 respectively.
For example:
Blink Field ON/OFF
D 7 D 6 D 5 D 4
X
X X X
X
X X X
Underbar On
*
Sets the underbar to ON at the current character position.
Underbar Off
*
Sets the underbar to OFF at the current character position.
Screen Saver On
Sets the display screen to brightness level 07h (dimmest) after a 10 minute idle time.
(Any new control or data input resets the Screen Saver function for another 10 minute cycle, The
Screen Saver function remains active.)
Screen Saver Off
Restores the screen display to previously established brightness level(s) and deactivates the
Screen Saver function. (Default)
Set Carriage Return and Line Feed Definitions
Sets the functions of the Line Feed (0Ah) and Carriage Return (0Dh) commands using a 2 byte
command consisting of control code 37h and the function ID.
Function ID
00h
01h
02h
03h
Set Right to Left Data Entry
Reverses data entry mode for use with Hebrew Character Set.
Set Left to Right Data Entry
Restores data entry mode to normal ASCII. (Default)
Applies to 036X2–151–05240 & 036X2-160-05440 only. Unassigned for all other models.
Line Position
D 3 D 2 D 1 D 0
0
0 0 1
1
1 0 0
Definition
LF = LF
CR = CR (Default)
LF = LF + CR
CR = CR
LF = LF
CR = CR + LF
LF = LF + CR
CR = CR + LF
SIZE
CODE IDENT NO.
A
05464
SCALE
N/A
Erase line 0, retain lines 1, 2, 3.
Erase lines 2 & 3, retain lines
0 & 1.
S036X2–XXX–XXXXX
SHEET
N
REV
32 of 49
Advertisement
Table of Contents
