Power/Data Connector; Personality Jumper Positions; J1 Contact Arrangement - IEE 036X2-121-11120 Reference Manual

3.2.3 Personality Interface (Continued)
9600
Jumper positions are shown above for LCD mode. Filled positions are settings without Interface Converter.
Baud rate jumper must be moved to 1200 (hatched) position if an Interface Converter is installed.
3.2.4

Power/Data Connector

The Power/Data connector (J1) contact arrangement is shown in the illustration below. See Table 3–4 for
pin assignments.
The 36X2-134 model has a separate power connector J2 and the pin assignments are:
IEE recommends that the user install a keying plug in the mating connector at
the Pin 8 location. This will assure that the mating connector is always
installed correctly and will avoid damage to the display.
Industrial Electronic Engineers, Inc.
Van Nuys, California
04/10/02
19200
1200

Personality Jumper Positions

2
1

J1 Contact Arrangement

J2-1
J2-2
J2-3
J2-4
J2-5
J2-6
IEE supplied accessory connectors are properly keyed.
INTEL LCD
MOT
Figure 3–10
Pin 8 Removed for Keying
Figure 3–11
+5VDC
NC
NC
COMMON (GND)
NC
NC
NOTE
SIZE CODE IDENT NO.
A 05464
SCALE N/A
REV
SFTST
NORM
20
19
S036X2–XXX–XXXXX
SHEET 19 of 49
N