Table of Contents
Advertisement
®
Radio Key
RK-65K
PROGRAMMING STEPS
To program the Radio Key
program mode as described in the next section below. Once in
the program mode, the LED will blink amber as an indicator. To
take the unit out of program mode you may select an operating
mode (see page 14) or simply allow 15 seconds to elapse without
presenting a program card to the reader.
After you have completed a proper program sequence, the
unit will beep and the LED will fl ash green to indicate that the
program instruction has been accepted. A red light and a beep
at the end of a programming sequence means that you have
made an error. Refer to the appropriate section, and carefully
re-enter the command in the proper sequence.
NOTE: User ID Number and ID Number Values in
the following examples are for demonstration
purposes only; enter the appropriate values for
your system.
®
RK-65K, you must fi rst enter the
Secura Key
Operating Guide
7
Advertisement
Table of Contents
