Identification Of Parts - Tyco 3G4000W Installation Manual

CONNECTING THE 3G4000W
TIP (1) / RNG (2) External Telephone Line - If the 3G4000W is being used as a back-up communicator, these terminals must be
connected directly to the incoming telephone line.
T1 (3) / R1 (4) Internal Telephone Line - These terminals must be connected to the TIP and RING of the control panel.
Zone 2 (7) Programmable Input - This terminal can be set up to trigger events. Refer to `Input' for details.
PGM2 (8) Programmable Open-collector Output - This output can be activated by programmed events. Refer to 'Activating the
Output' for details. The maximum current sink of each output must not exceed 50mA.
DC in + (9), DC in - (10) Device Power Supply - These terminals must be connected to a rated power supply. Once the
connections are completed, connect the battery, [12] in Figure 1) to a 7.2V, 2.2Ah battery.
NOTE: When disposing of batteries, follow the instructions and precautions printed on the batteries, and contact your municipal
offices for information on the disposal of used batteries.

Identification of Parts

Table 1: Parts
Parts
1 Plastic Casing
2 Anchor Screw Holes (3mm)
3 SIM Card Holder
4 2G/3G External Antenna*
5 2G/3G (HSPA) Radio Module
6 Antenna Connector
7 Antenna Mounting Hardware
8 Cover Tamper Switch
9 Status LEDs
10 Terminal Blocks
11 PC-Link Connector
12 Battery Connector
13 Cable Entry
14 7.2V - 2.2Ah Battery
15 Cable Run Knockout
16 Wall Tamper Switch
* Use only DSC provided antenna.