MP-902 PG2
Wireless outdoor curtain PIR detector with anti-masking and pet immunity
1. Overview
The MP-902 PG2 is a smart, wireless outdoor curtain PIR detector with
anti-masking. It is supported by the PowerMaster alarm system and uses
PowerG two-way communication protocol.
The detector has the following features:
Two channel Pyro (patented) thermal sensor output
l
Microprocessor-controlled temperature compensation
l
White light protection
l
Adjustable pet immunity selector with three options: no pet, a small pet
l
weighing less than 3 kg or 6.6 lb, or a pet weighing less than 18 kg
or 40 lb.
Adjustable detection sensitivity
l
Parabolic and elliptical optics (patented)
l
Target Specific Imaging™ (TSI) technology distinguishes between
l
humans and pets weighing up to 18 kg or 40 lbs
True Motion Recognition™ algorithm (patented) distinguishes
l
between the true motion of an intruder and any other disturbances
which may cause false alarms.
Cross-direction detection: both directions, left to right, and right to left.
l
Active smart anti-masking ability recognizes spray and dust (patented)
l
No vertical adjustment is needed.
l
Long-life battery which is due to the ultralow current consumption
l
Front and back tamper protection (patented)
l
Supports temperature and light level reports according to the PowerG
l
panel version
Note: For UL installations, only use the device with UL listed control units.
2. Installation advice
Qualified service persons only can install the MP-902 PG2. Before you install the device, consider the following points:
Do:
Install the MP-902 PG2 according to the Standard for Installation and
l
Classification of Burglar and Holdup Alarm Systems, UL 681.
Mount the detector so that the expected movement of the intruder will
l
cross the PIR beam.
Mount the device on a vertical surface and as straight as possible.
l
Mount the device upright. See Figure 2.
l
Direct the detector at a stable surface, such as a wall or fence, to
l
provide a curtain detection boundary for better detection.
Mount the device at a height that agrees with your pet immunity
l
preference. See
Setting the pet immunity
Consider weather conditions that can trigger false alarms, such as
l
moving tree branches or leaves, and other related environmental
conditions
Locate the device at least 20 cm from all persons during normal
l
operation to comply with FCC and ISED Canada RF exposure
compliance requirements
Figure 2:
Mounting orientation
D-307164 MP-902 PG2 Installation instructions
Do not:
l
l
l
l
l
l
l
for more information.
l
Figure 3: Flat ground installation
Figure 1: MP-902 PG2
1. Bracket
2. Detector
3. Indication LED
4. PIR optical window
Install the device over sloped ground. See Figure 3.
Install the device close to tree branches as weather conditions can
cause movement, resulting in false alarms
Install the device in hazardous locations
Install the device in areas with a pollution degree higher than pollution
degree 2
Install the device in circuits above overvoltages category II
Obscure the field of view of the detector
Co-locate or operate the antennas used for this product in conjunction
with any other antenna or transmitter
Mount the device on surfaces where surface vibration can occur
Installation instructions
1