Standby Or Hibernation Problems - IBM ThinkPad A22e Supplementary Manual

Solving computer problems
Solution: Check the mouse driver in Device Manager window, and make sure
that the IBM PS/2 TrackPoint driver is installed.

Standby or hibernation problems

Problem: The computer enters standby mode automatically.
Solution: If the processor reaches a temperature that is too high, the computer
will automatically enter standby mode to allow the computer to cool and to
protect the processor and other internal components.
Problem: The computer enters standby mode immediately after POST (the
standby indicator turns on).
Solution: Make sure that:
v The battery is charged.
v The operating temperature is within the acceptable range. Refer to
"Specifications" in this Guide.
If these items are correct, have the computer serviced.
Problem: The
immediately turns off.
Solution: The battery power is getting low. Connect the ac adapter to the
computer, or replace the battery with a fully charged one.
Problem: The computer display remains blank after you take action to return
from a sleep mode.
Solution: Check if an external monitor was disconnected while the computer
was in standby mode. Do not disconnect the external monitor while the
computer is in standby mode or hibernation mode. If no external monitor is
attached when the computer resumes, the computer display remains blank
and output is not displayed. This restriction does not depend on the
resolution value.
Problem: The computer does not return from standby mode, or the standby
indicator stays on and the computer does not work.
Solution: The computer automatically enters standby or hibernation mode
when the battery is depleted. Do one of the following:
v Replace the battery with a fully charged one and then press Fn.
v Connect the ac adapter to the computer; then press Fn.
20
®
ThinkPad A22 Service and Troubleshooting Guide
appears, and the computer