Electrical Connection - Fisher & Paykel OR36SDI6 Installation Manual

WARNING!
Electrical Shock Hazard
Failure to follow these
instructions can result in death,
fire, or electrical shock.
Electrically ground range.
WARNING!
VERY IMPORTANT
To avoid electrical shock
hazard, before installing the
appliance, switch power OFF
at the service panel and lock
the panel to prevent the
power from being switched
on accidentally.
14

ELECTRICAL CONNECTION

IMPORTANT!
This range must be connected to the electricity supply only by an authorised person.
Your range is supplied with a certified 4 prong NEMA 14-50P power cord for your protection against shock hazard
and should be plugged directly into a properly grounded socket.
Do not under any circumstances cut or remove the fourth (ground) prong from the power plug.
z z
Do not ground to a gas pipe.
z z
Do not have a fuse in the neutral or ground circuit.
z z
Do not use an extension cord.
z z
Check with a qualified electrical installer if you are not sure if the range is properly grounded.
If codes permit, and a separate ground wire is used, it is recommended that a qualified electrical technician
z z
determines the ground path and wire gauge are in accordance with local codes.
Be sure that the electrical connection and wire size are adequate and in conformance with:
ANSI/NFPA 70 latest addition and local codes and ordinances.
z z
CSA standard C22.1, Canadian Electrical Code, Part 1 — latest edition and local codes and ordinances.
z z
When a 4-wire, two phase 120/240V or 120/208V 60Hz AC only electrical supply is available a 50 amp maximum
circuit protection is required, fused on both sides of the line.
Replacing the power cord
Replacements should only be made by qualified electrical technicians.
z z
If replacing the power cord, use only a suitable UL or CSA approved one.
z z
Tighten the power cord using the power cord strain relief bracket supplied with the appliance.
z z
Allow enough slack to easily attach the cord terminals to the terminal block.
z z
VOLTAGE AND POWER CONSUMPTION*
AC 120/208 V 60 Hz 11600 W Max 55.5 A Max
AC 120/240 V 60 Hz 15500 W Max 64 A Max
Induction power = 11100 W Max
Standard NEMA 14-50R wall receptacle
*The NEC calculated load is less than the total connected load listed on the rating label.
Standard NEMA
14-50R wall receptacle
NEC CALCULATED LOAD
40A*
40A*
Power supply cord with
Power supply cord with
NEMA 14-50P plug NEMA 14-50P plug
Location of
nameplate