Fisher & Paykel DCS ActiveSmart RS36W80 User Manual page 27

RS36A80 and RS36W80 models only
To clean the bottom kickstrip
grille and kickstrip filter:
Remove the air flow divider by
1
pulling towards you (A).
To remove the top kickstrip grille,
2
insert fingers into the left and
right square openings on the
grille. Pull towards you (B).
To remove kickstrip filter, insert
3
fingers into the left and right
square openings on the filter. Pull
towards you. Refer to 'Removing
and replacing kickstrip filter'
drawing.
Clean both components with
4
liquid dishwashing detergent
dissolved in warm water and a
soft lint-free cloth.
Rinse with clean water and dry
5
with a clean, lint-free cloth.
To replace kickstrip filter and
kickstrip grille:
To replace kickstrip filter, align
1
filter tabs onto the rails and push
to the rear until it clips securely.
To replace top kickstrip grille,
2
align securing hooks then firmly
push grille onto product until it
clips securely (C).
To replace air flow divider, align
3
the divider underneath the grille
tabs indicator and clip onto the
vanes of the bottom grille (D).
CLEANING CARE – EXTERIOR
1. IF TOEKICK IS HIGHER THAN 4" U
CUT UNREQUIRED VANES FROM
Removing air flow divider
2. DRILL HOLES THROUGH DIMPLE
3. USE PROVIDED SCREWS TO FIX G
MATCHING HOLES ON PLASTIC
B
Removing top kickstrip grille
C
Replacing top kickstrip grille
Replacing air flow divider
A
D
25