The Dot Display Symbols And Their Meaning; How To Change The Mode; Time And Calendar Mode - Citizen HYPER AQUALAND MA9XXX User Manual

The dot display symbols and their meaning

<Mode display>
: Time calendar mode
: Alarm mode
: During the measurement of temperature
: Log mode (The display when there is no
profile data recorded)
: Log mode (The display when profile data
has been recorded)
: Surface mode (Time elapsed after
completing a valid dive)
: Transfer mode
: Data presently being transferred
Warning Display
: Ascending speed warning
: (D201/D207) /
: Various checks (*without (D202/D208))
: Various errors
*Please look at the N. [The log mode] for an
explanation about profile data.
G. How to change the mode
The mode changes by pressing button
the water sensor gets wet.
* Surface mode cannot be acquired unless a valid
dive is done.
* Change to the transfer mode by pressing the
button for more than 2 seconds from any mode.
*Change to the transfer mode by pressing
for more than 2 seconds from any mode.
: Press (M) button once
M
: Press (M) button for more than 2 seconds
M
: Displayed only in surface mode
: Auto return
H. Time and calendar mode
[This is the function which displays present time and
present calendar.]
• In normal time mode, a LED, which is situated at
12 o'clock, flashes a time signal for 3 seconds on
every hour. (ex 7:00:00, 01, 02)
: Dive mode (Diver is swimming)
: Ready for diving
(D202/D208): Battery Warning
or when
M
M
button
M
• By pressing button in the time and calendar
A
mode, the watch is in temperature measuring state
(1st temperature display state). In this mode the
temperature is measured every 10 seconds for 3
minutes. However, until the first measurement is
taken it displays [--°C].
• After 3 minutes the watch automatically changes to
(the 2nd temperature display state) where
temperature is measured every 30 minutes. The
range of temperature measurement is between –
5°C to 40°C (23°F~104°F). However, while the
watch is on your wrist the correct temperature
cannot be measured properly, so please remove
the watch from your wrist to get accurate readings.
• In the time and calendar mode, you can confirm
the LED flashes by pressing the
(Flashes 5 times)
• The display light will stay on for up to 10 seconds
while you press button. The display light will
C
switch off 1.5 seconds after releasing the
button once.
B
button.
C