Table of Contents
Advertisement
* The surface mode is no longer displayed once measurement of no fly time (timer) is completed
after scuba diving. The watch switches to the time mode of the standard mode when button
(D) is pressed in the skin log mode when the surface mode is not activated.
* When none of the buttons are pressed for about 3 minutes in any of the modes of the
standard mode, dive plan mode, scuba log mode or skin log mode, the watch automatically
returns to the time mode of the standard mode (except that it returns to the surface mode
when the surface mode has been activated).
* The watch switches to the low power mode when buttons (A) and (D) are pressed for at least
2 seconds in the time mode of the standard mode.
* If "BATT", "ERR" or "CHK" is flashing in the lower left section of the display in any of the modes
(indicating that a warning function has been activated), and during correction in any mode, the
watch does not switch to the dive mode even if the water sensor gets wet.
* The hourglass mark and "LOADING" are displayed when switching to the dive mode, infrared
communication mode or low power mode. The water sensor along with all button operations
do not function while these are displayed.
U U s s i i n n g g t t h h e e E E L L L L i i g g h h t t
The EL light is illuminated for about 1 second when the EL
light button on the front of the watch is pressed in any of the
modes except for the infrared communication mode. The
EL light is illuminated for about 5 seconds when the EL light
button is pressed continuously.
CAUTION
Since the display may be difficult to see when confirming the display during night
diving, confirm the contents of the display with external lighting such as an
underwater light.
94
(
C
)
(
B
)
(
D
)
(
A
)
EL light button
U U s s i i n n g g t t h h e e S S t t a a n n d d a a r r d d M M o o d d e e
1. Time Mode
This mode is the basic mode of this watch and is used to correct and display the time and
date.
A. Switching the Display
• The display switches between the Day Display and Location Display each time button
(C) is pressed.
• When button (B) is pressed when either the Day Display or Location Display is displayed,
the display changes to the Enlarged Display. Pressing button (B) again returns it to the
original display.
[Day Display]
Time
(
C
)
(
B
)
Month, date
(
D
)
(
A
)
Daily graphic
Day
(C)
[Location Display]
Alarm ON
mark
Battery Charge
indicator
Location
B. Setting the Time and Date
(1) The watch enters the correction state (display is flashing) when
button (C) is pressed for at least 2 seconds during any display of
the time mode.
(2) The location on the display that is flashing changes in the order
shown below each time button (C) is pressed.
(C)
(C)
Daylight savings
Location
Seconds
time switching
(C)
(C)
Contrast
12H/24H format
(CONT)
switching
[Enlarged Display]
(
C
)
(B)
(
D
)
Time
Flashing
(C)
(C)
Minutes
Hours
(C)
(C)
Date
Month
Year
(
B
)
(
A
)
(C)
95
Advertisement
Table of Contents
