General Information; Reading And Storing The User Manual; Checking The Dumo And Dumo Rf Package Contents; Overview Of The Life Cycle Operation - ProDetec Sintrol Dumo User Manual

1 General Information

1.1

Reading and storing the user manual

This user manual accompanies the Dumo and Dumo RF dust measuring instrument (hereafter referred to as
the „Dumo"), and contains important information on installation, setup, calibration, handling and
maintenance.
Before using the Dumo, read the user manual carefully. This particularly applies to the safety instructions.
Failure to do so may result in personal injury or damage to the Dumo. This user manual must accessible to
those tasked with the installation and operation of the Dumo.
Store the user manual for further use. Make sure to include this user manual when passing the instrument on
to third parties.
1.2

Checking the Dumo and Dumo RF package contents

Be careful when opening and removing the instrument from the packaging.

1. Take the instrument out of the packaging.
2. Check to make sure that the delivery is complete (see 4.1 Standard Scope of delivery).
3. Check whether the Dumo or individual parts are damaged. If this is the case, do not
use the instrument and contact the Sintrol Customer Service Department.
1.3

Overview of the life cycle operation

After unpacking the instrument, the whole life cycle operation shall be handled as follows:
 Choose the appropriate installation location (see chapter 6 Mechanical Installation)
 Install the instrument mechanically (see chapter 6 Mechanical Installation)
 Install the instrument electrically (see chapter 7 Electrical Installation and Wiring)
Run Auto setup at normal conditions while production is running (see chapter 8.2 Auto setup

description)
 Change parameters and calibrate the instrument if necessary by using
o The selectable parameter sets (see chapter 8.4 Selectable parameter sets )
o or the local user interface buttons (see chapter 8.5 Parameter table for the local display)
o or any of the Sintrol software (see chapter 9 Sintrol DustTool Software)
Use the instrument according to this manual

 Clean and maintain the instrument periodically (see chapter 11 Cleaning and Maintenance)
If required do troubleshooting (see chapter 12 Troubleshooting)

If you relocate the instrument repeat the whole installation, Auto setup and calibration procedure

 At the end of lifetime dispose the Instrument according to this manual (see chapter 16 Disposal)
Risk of damage!
If you are not cautious when opening the packaging with a sharp knife or
other pointed object, you may quickly damage the instrument.
Page 5 | 49