Troubleshooting; No Output Signals; No Response After Auto Setup - ProDetec Sintrol Dumo User Manual

12 Troubleshooting

12.1 No output signals

Check that the power and signal wiring are connected correctly.

Check that there is power on.

Run the auto setup.

If the Dumo is not giving an output signal after these checks, contact your local distributor.

12.2 No response after auto setup

 Make sure that normal processes are going on during auto setup.
 Check that the power and signal wiring are connected correctly.
If the Dumo is not giving an output signal after these checks, contact your local distributor.
Page 42 | 49