ECO2 Systems SANCO2 GS4-45HPC Installation Manual page 25

No.00
No.01
No.02
No.03
No.04
No.05
No.06
No.07
No.00 Tank TH A temp
No.08
No.04 Outlet water temp
No.09
No.10
No.05 Inlet water temp
No.11
No.07 Ambient temp
No.012〜99
To bypass the Parameter Display, simply press the UP key to return the first option mode
in the Commissioning menu
To Exit Commissioning Mode, hold Enter Key or do not press any key for 60 seconds and
To Exit Commissioning Mode, do not press any key for 60 seconds and Control will default
Control will default to sleep mode and revert to the current time display when awoken.
to sleep mode and revert to the current time display when awoken.
Air Bleeding Mode
Enter into Commissioning Mode
First option is the Heat Setting
Second option is Block Out Time
Third option is Error histopry
Fourth option is Paraeter Display-
Press the UP Key to access Air bleeding Mode then Enter to access
In this mode pump run for 5 minutes to bleed air inside of piping.
Tank TH A temp
Outlet water temp
Inlet water temp
Factory Default Value
Factory Default Value
Factory Default Value
Ambient temp
Factory Default Value
Factory Default Value
Factory Default Value
Factory Default Value
Factory Default Value
Empty
SANCO Heat Pump – Installation Manual
2
Page 25 of 44