Table of Contents
Advertisement
VGM, VGD-0505
2.
Increase the height to 12", and raise and lower the
glass 6 more times.
3.
Finally, raise the glass to it's full extension. This should
release any settled lubricant in the cylinders, and
prevent any stress on the front glass. (1)(3)
G L A S S R E P L A C E M E N T & R I G H T – L E F T A D J U S T M E N T
1. Open glass
panel.
Relieve the
tension on
the hinge.
PVC
U-channel
3. Use tip of
screwdriver to
gently tap loose
wedge the entire
length of the panel
1 2
Maintenance (cont.)
2. Back out
all the set screws
along the top
edge of the glass
panel
(3mm set screw)
4. Slide glass panel
in desired direction
or remove panel
FOR PROMPT SERVICE
When Contacting the Factory
regarding problems, Be sure
to have the Case MODEL and
SERIAL NUMBER Handy.
This Information is on a plate
located on the case itself.
Inside
of Case
Back
of Case
Advertisement
Table of Contents
