Troubleshooting - LOCO COOKERS LCTFKESB30 Owner's Manual & Assembly Instructions

PROBLEM
Burner will not light.
Burner does not stay lit. Excessive wind conditions.
Oil does not reach
desired cooking
temperature.
lococookers.com

TROUBLESHOOTING

POSSIBLE CAUSE
Bad connection between the
regulator and LP tank.
The LP tank is empty.
Ignition button was not pushed
and held.
Battery not installed correctly.
Weak or dead battery.
Battery cap not installed
correctly.
Smart Temp heat sensor has
extinguished fl ame due to
excessive oil temperature.
Turkey is not fully thawed/
defrosted.
Regulator control valve is not
fully opened.
Overfi ll Protection Device (OPD)
on LP tank has been activated/
tripped.
SOLUTION
Make sure the regulator coupling nut is
fully tightened on the LP tank valve.
Refi ll LP tank at an authorized dealer
or purchase new fi lled LP tank.
Press and hold the ignition button for
30 seconds while lighting burner.
Make sure the + and – ends of the
battery are oriented properly. The +
end should be toward the battery cap.
Replace with new alkaline AAA battery.
Unscrew battery cap and reinstall.
Make sure threads are aligned and
engaged fully.
When appliance is cool, move
appliance to diff erent location where
high wind is not a factor. Relight
burner.
Turn the regulator control valve and
the LP tank valve OFF. Allow oil to cool
and relight burner.
Never attempt to fry a frozen or
partially frozen turkey. Make sure
turkey is fully thawed/defrosted and
towel dried before lowering into oil.
Fully open regualtor control valve by
rotating it in a clockwise direction.
To reset the Overfi ll Protection Device,
turn the regulator control valve and
the LP tank valve OFF. Disconnect the
regulator from the LP tank and wait
at least one minute. Reconnect the
regulator to the LP tank and fully open
LP tank valve.
17