Clutch Lever - Yamaha R3 Owner's Manual

Horn switch " "
Press this switch to sound the horn.
Start/Engine stop switch " /
To crank the engine with the starter,
set this switch to " ", and then slide
the switch toward " ". See page 6-2
for starting instructions prior to starting
the engine.
Set this switch to " " to stop the en-
gine in case of an emergency, such as
when the vehicle overturns or when the
throttle cable is stuck.
Hazard lights switch " /OFF"
The hazard lights (simultaneous flash-
ing of all turn signal lights) are used in
case of an emergency, such as to warn
other drivers when your vehicle is
stopped where it might be a traffic haz-
ard.
Set this switch to " " to turn on the
hazard lights. To turn off the hazard
lights, set the switch to "OFF".
EAU12501
NOTICE
Do not use the hazard lights for an
extended length of time with the en-
EAU68270
/ "
gine not running, otherwise the bat-
tery may discharge.
EAUN2210
Instrument and control functions
ECA10062

Clutch lever

1. Clutch lever
To disengage the drivetrain from the
engine, such as when shifting gears,
pull the clutch lever toward to the han-
dlebar. Release the lever to engage the
clutch and transmit power to the rear
wheel.
TIP
The lever should be pulled rapidly and
released slowly for smooth shifting.
(See page 6-3.)
4-10
1
EAU12823
4