Handlebar Switches - Yamaha R3 Owner's Manual

Instrument and control functions
r/min to 13500 r/min, the indicator
light can be set in increments of
200 r/min.
Be sure to set the deactivation
point to a higher engine speed
than for the activation point, other-
wise the shift indicator light will not
come on.
4
1. Push the "RESET" button to select
the desired engine speed for de-
activating the indicator light.
2. Push the "SELECT" button to con-
firm the selected engine speed.
The control mode changes to the
brightness setting mode.
To adjust the brightness
1. Push the "RESET" button to select
the desired shift indicator light
brightness level.
2. Push the "SELECT" button to con-
firm the selected brightness level.
The display exits the shift indicator
light control mode and returns to
the standard multi-function dis-
play mode.

Handlebar switches

Left
1
2
4
1. Pass switch "PASS"
2. Dimmer switch " / "
3. Horn switch " "
4. Turn signal switch " / "
Right
1
2
1. Start/Engine stop switch "
/
2. Hazard lights switch "
4-9
EAU1234M
Pass switch "PASS"
Press this switch to flash the headlight.
TIP
When the dimmer switch is set
to " ", the passing switch has no ef-
fect.
Dimmer switch "
Set this switch to "
3
beam and to "
TIP
When the switch is set to low beam,
both headlights for low beam come on.
When the switch is set to high beam,
both headlights for high beam come
on.
Turn signal switch "
To signal a right-hand turn, push this
switch to "
turn, push this switch to "
released, the switch returns to the cen-
ter position. To cancel the turn signal
lights, push the switch in after it has re-
/ / "
turned to the center position.
"
EAU12362
EAU85410
/ "
" for the high
" for the low beam.
EAU12461
/ "
". To signal a left-hand
". When