Troubleshooting; Technical Data - ALDI FERREX FABH 20-I User Manual

Troubleshooting

Problem
Device does not
work
The On/Off
switch 4 is not
functioning.
The product will
not start.
The drill bit does
not penetrate or
barely penetrates
the material to be
drilled into.
If faults and malfunctions are not listed here, contact the manufacturer's After Sales
Support via the service address indicated on the warranty card.

Technical data

Article number:
Model:
Model number:
Idle speed n :
0
Number of strokes
Shifting gear:
Impact energy:
Drilling capacity:
Absorption capacity of the quick-ac-
tion drill chuck:
Possible cause
The rechargeable battery (not
included in the package con-
tents) is not charged.
The switch (right-hand/left-
hand rotation) 3
middle position.
The carbon brushes may be
worn out.
You are using an incorrect drill
unsuitable for the material to
be drilled into.
You want to drill into con-
crete or masonry and the
switch (right-hand/left-hand
rotation) 3 is set to the left-
hand rotation.
802099
FABH 20-I
WU5420373 / WU5420374
0–900 rpm
0–5000 min
:
Drilling, hammer drilling
1.2 joules
Concrete: 10 mm
Steel: 8 mm
Wood: 16 mm
Ø 0.8–10 mm
Solution
Charge the rechargeable
battery.
Set the switch to right-hand or
is in the left-hand rotation.
Contact a qualified workshop.
Select the right drill bit.
Switch the drill to hammer drill-
ing and set the switch (right-
hand/left-hand rotation) to
right-hand rotation in order to
drill this material.
-1
Troubleshooting
23