Cleaning And Maintenance; Cleaning The Product - ALDI FERREX FABH 20-I User Manual

− Please be sure to put down or pick up the product in a switched-off state. Rotating
tools can slide off.
− Use only drill bits that are suitable for the respective material to be machined.
− Do not use dull drill bits.
− Do not start drilling into tiles using the 'Hammer drilling' setting (see chapter 'Set-
ting the mode and direction of rotation'). If you do, the ceramic can shatter. Drill at
low speed. As soon as you have drilled through the hard glaze, you can switch on
the 'Hammer drilling' setting and finish drilling.
− For walls of unknown material or for plaster walls, drill a test hole without the
'hammer drilling' setting. If you want to drill a hole into concrete, the drill will pen-
etrate only a little or not at all. Plaster can be drilled into without excessive force.

Cleaning and maintenance

WARNING!
Risk of electric shock!
Do not immerse the product or let it come into contact with water or other liq-
uids. There is a risk of electrocution.
− Put the switch (right-hand/left-hand rotation) to the middle position to
prevent the product from switching on accidentally.
− Remove the rechargeable battery from the product.
NOTICE!
Risk of damage!
Improper cleaning may damage the product.
− Do not use any aggressive cleaners, brushes with metal or nylon bristles,
sharp or metallic cleaning utensils such as knives, hard scrapers and the
like. They could damage the surfaces.

Cleaning the product

− Clean the product after each use.
− Clean the outside of the product and the quick-action drill chuck regularly with a
dry or slightly moist cloth.
Cleaning and maintenance
21