Using The Screwdriver Bits - ALDI FERREX FABH 20-I User Manual

Operation
The securely engaged quick-action drill chuck can be moved slightly, but it cannot
be completely extracted from the SDS-Plus shank holder.
7. Rotate the quick-action drill chuck anticlockwise until you can insert the desired
drill bit (not included in package contents).
8. Insert the drill bit into the quick-action drill chuck up to the stop point.
9. Rotate the quick-action drill chuck clockwise until the drill bit is clamped firmly in
place.
10. After the work: Make sure that the product has stopped moving, and lock the On/
Off switch by pushing the switch (right-hand/left-hand rotation) to the middle
position.
11. Remove the rechargeable battery from the product.
12. Rotate the quick-action drill chuck anticlockwise until you can pull out the drill bit
from the quick-action drill chuck.
13. Pull the locking mechanism of the SDS-Plus shank holder on the product as far
back as possible in order to pull out the quick-action drill chuck from the SDS-Plus
shank holder.

Using the screwdriver bits

1. Make sure that the product is not moving, and lock the On/Off switch
ing the switch (right-hand/left-hand rotation)
(see Fig. A).
2. Pull the locking mechanism of the SDS-Plus shank holder
back as possible and hold it in this position (see Fig. B).
3. Insert the shank of the quick-action drill chuck
on the product and release the locking mechanism so that the quick-action drill
chuck clicks into the shank holder.
4. Before you start working, make sure that the quick-action drill chuck has securely
locked in place in the SDS-Plus shank holder by trying to pull it out of the SDS-Plus
shank holder:
The securely engaged quick-action drill chuck can be moved slightly, but it cannot
be completely extracted from the SDS-Plus shank holder.
5. Rotate the quick-action drill chuck clockwise until you can insert the desired drill
bit adapter or screwdriver bit (not included in package contents).
6. Insert the desired screwdriver bit or the drill bit adapter with the appropriate in-
sertion depth into the quick-action drill chuck.
7. Rotate the quick-action drill chuck anticlockwise until the screwdriver bit or the
drill bit adapter is clamped firmly in place.
8. After the work: Make sure that the product has stopped moving, and lock the On/Off
switch by pushing the switch (right-hand/left-hand rotation) to the middle position.
16
3 to the middle position
2 on the product as far
6 into the SDS-Plus shank holder
4 by push-