Faq And Solutions - Xvico pioneer Operation Instraction

⚫
When the nozzle is too far from the printing
platform：
⚫ The printed model is uneven, curled with gap.
The consumables fall down to the hot bed by
gravity and form a rounded strip. The
adhesion effect is not good and the model is
easy to move.
so bad.
⚫
Appropriate distance：
Printed model flat with no gap, no glitches,
that the printed filaments are pressed against
the hot bed to form a flat ribbon (flat)。
Warm tips : In order to make the printing model adhere to the printing platform better, it
is recommended to apply solid glue to the glass before printing.
Symptom
No.
1
Print model dislocation
Glitch with the print
2
model
3
Foamy print model
making the printing effect
ensuring

FAQ and Solutions

Synchronous wheel/belt loose.
Too high temp or slicing problem.
Low temp or not smooth
filament entering.
Reason
Extruder temp is too high and retracting
speed & distanse is too small
Rise extruder temp or check if brass nut
and bearing is good. Replace a nozzle if
methods above can't solve the problem.
Method
Tighten set screws or fasten belt