Print Platform Leveling - Xvico pioneer Operation Instraction

Filament replacement：
3.
3.1. Please preheat the printer to 200°；
3.2. When the temperature reaches 200°, the thumb presses the feed handle, while
the other hand first presses the filament downwards to feed a filament item, and
then pulls out the filament at a constant speed.；
3.3. Then install the new filament according to the "Install filament" method。
Caution:
1. In order to avoid filament to send too deep to pull out, causing secondary refeeding
difficulties, when the filament approach the end of the printing, remember that the
machine can not send all the filament into the feeding port, and it is necessary to replace
the new filament in time;
2. When replacing a new filament, the printer needs to be preheated. Remember that it
cannot be hard-drawn or cold drawn to avoid irreparable damage to the extruder.
1.
Click "one-key leveling" in the application interface
interface，The printer will automatically zeroing by this time。
Retraction filament method (take PLA as an example)：

Print platform leveling

，enter into leveling