Fisher & Paykel DCS BGC Series Installation Instructions And User Manual page 13

INSTALLATION
BUILT–IN CONSTRUCTION DETAILS
Access Drawers
Cutout dimensions
NOTE: The cutout of each corner should be 90
to fit properly.
* Island installation to use minimum of 3 vents, 10 square inches (25,4cm2) per vent
(typical).
** For proper support and drawer operation, insure that support boards are
installed per Installation Guide instructions
MODEL NUMBER
(+0,-1/8)
ADR2- 48
ADR2-36
ADR2-30
ADR2-24
To order access drawers or doors, please call DCS Customer Care at 1.888.936.7872 for DCS Dealer in your area.
FIG. 05
angle in order for the access drawers
º
A B C
(+1/8,-0)
24-1/2"
46" 20"
34" 20" (Min,
28" 20" All
22" 20" Models)
Access Doors
Cutout dimensions
Vent*
90º
Cutout for Access Doors
NOTE: The cutout of each corner should be 90
for the access drawers to fit properly.
* Island installation to use minimum of 3 vents,
10 square inches (25,4cm2) per vent (typical).
MODEL NUMBER
ADN1-20x48
ADN1-20x36
ADN1-20x30
ADN1-20x24
11
Vent*
A
B
FIG. 06
angle in order
º
A B
(+0,-1/8) (+1/8,-0)
46" 20"
34" 20"
28" 20"
22" 20"
Vent*