Controls; Engine Shut-Off Cord (Lanyard); Engine Oil - Yamaha F75 Owner's Manual

Operation
EMU36900

Controls

Tiller handle models:
Turn the tiller handle fully to the left and
G
right to make sure operation is smooth.
Turn the throttle grip from the fully closed to
G
the fully open position. Make sure that it
turns smoothly and that it completely re-
turns to the fully closed position.
Look for loose or damaged connections of
G
the throttle and shift cables under the en-
gine cowling.
Remote control models:
Turn the steering wheel full-right and full-
G
left. Make sure operation is smooth and un-
restricted throughout the whole range with
no binding or excessive free play.
Operate the throttle levers several times to
G
make sure there is no hesitation in their
travel. Operation should be smooth over
the complete range of motion, and each le-
ver should return completely to the idle po-
sition.
Look for loose or damaged connections of
G
the throttle and shift cables under the en-
gine cowling.
EMU36481

Engine shut-off cord (lanyard)

Inspect the engine shut-off cord for damage,
such as cuts, breaks, and wear.
1. Cord
2. Clip
3. Engine shut-off switch
48
1. Cord
2. Clip
3. Engine shut-off switch
EMU27165

Engine oil

1. Put the outboard motor in an upright po-
sition (not tilted). NOTICE: If the motor
is not level, the oil level indicated on
the dipstick may not be accurate.
[ECM01790]
2. Remove the top cowling.
3. Remove oil dipstick and wipe it clean.
4. Insert the dipstick and remove it again.
Be sure to completely insert the dipstick
into the dipstick guide, otherwise the oil
level measurement will be incorrect.
5. Check the oil level using the dipstick to be
sure the level falls between the upper and
lower marks. Fill with oil if it is below the
lower mark, or drain to the specified level
if it is above the upper mark.
1. Oil dipstick
1
ZMU05368