Rev.0303
Install Hinge Hardware onto glass (left and right)
1. Install hardware onto glass , inside right, 6" in from the end.
Hinge rod will protrude within the 6 inches, pointing
to the outside of the glass.
2. Tighten down allen screws with 3mm Allen wrench.
Illustration 2
Install Case Hinge Hardware
Install Upper Hinge Hardware on case
1.Place "upper hardware with piston on case about 1'-6" from end.
2. Tighten own only enough to keep on track. It needs to be
loose enough to slide to the right and attach piston to glass.
Install Lower Hinge Hardware on Case
1. Install on lower track.. Inside edge of the hardware
about 6" from end of case.
2. Tighten allen screws down with 3mm Allen Wrench.
Piston
Upper Hardware
15
Lower Hardware inside
edge installed 6" from
edge of case.
6"