Table of Contents
Advertisement
IGA Manufactures Association
Caution! Do not touch the print cartridge ink nozzle or copper contacts. Touching
these parts will result in clogs, ink failure, and bad electrical connections. Do not
remove the copper strips. They are required electrical contacts.
1. copper contacts
Press the print cartridge firmly into the cradle.
Secure the cradle latch.
Close the top cover.
Caution! If you are in the middle of printing, and you change a print cartridge, your current print job
may be cancelled.
If the Print Cartridge Status LED continues to flash after installing a new print
cartridge, check the part number on the cartridge.
4.4
Maintaining Print Cartridges
The following suggestions will help maintain HP print cartridges and
ensure consistent print quality:
Keep all print cartridges in their sealed packages in an upright position until they are needed. Print cartridges
should be stored at room temperature (60–78 degrees F or 15.6–26.6 degrees C).
Do not remove the plastic tape covering the ink nozzles until you are ready to install the print cartridge in the
printer. If the plastic tape has been removed from the print cartridge, do not attempt to reattach it. Reattaching the
tape damages the ink nozzles.
If print cartridges are removed from their sealed containers, store them in an airtight container. For best results,
store the black cartridge with the nozzle side up and the color cartridge with the nozzle side down. Do not allow
anything to touch the nozzle plate.
Once the print cartridges are installed in the printer, do not remove them unless they need to be manually
cleaned. This prevents ink from evaporating or clogging the print cartridges.
Do not unplug the printer until printing is complete and the printer is turned off. Use the Power button to turn off
the printer.
4.5
Refilling of Print Cartridges
10/2004
User Manual ODP 100
39
Advertisement
Table of Contents
