Cisco NME-16ES-1G Features Manual page 68

Troubleshooting the Cisco EtherSwitch Service Module Software
7.
8.
9.
DETAILED STEPS
Command or Action
Step 1
service-module interface slot/port
password-reset
Example:
Router# service-module gigabitethernet2/0
password-reset
Step 2
flash_init
Example:
Switch: flash_init
Step 3
load_helper filesystem:/file-url ...
Example:
Switch: load_helper flash: xyz
Step 4
control+6 x
Example:
Switch: control+6 x
Step 5
disconnect
Example:
Router# disconnect 1
Step 6
copy flash: xmodem:
Example:
Router# copy flash: xmodem:
or
copy tftp: xmodem:
Example:
Router# copy tftp: xmodem:
Step 7
service-module interface slot/port session
Example:
Router# service-module gigabitethernet1/0
session
Cisco IOS Release 12.2(25)SEC
68
service-module interface slot/port session
dir flash:
boot flash: image
Cisco EtherSwitch Service Modules Feature Guide
Purpose
Ensures that the switch stays at the boot loader prompt, so
that you can copy a new image through the Xmodem
Protocol.
Initializes the flash memory file system on the switch.
Loads and initializes one or more helper images.
Returns you to the router console while keeping the console
session to the switch intact.
(Use x to get back to the router prompt.)
Disconnects the switch session to begin the Xmodem
download.
Starts the file transfer from the router flash memory by
using the Xmodem Protocol from the router prompt.
Starts the file transfer from a TFTP server from the router
prompt.
Connects to the service module and opens a Cisco
EtherSwitch service module session.