Cisco NME-16ES-1G Features Manual page 42

How to Configure the Cisco EtherSwitch Service Module
Default Settings After Initial Cisco EtherSwitch Service Module Configuration
The Cisco EtherSwitch service module is designed for plug-and-play operation. You need only assign
basic IP information to the Gigabit Ethernet interface on the router representing the Cisco EtherSwitch
service module and open a console session to Cisco EtherSwitch service module. You can then connect
any other devices to the switch ports. If you have specific network needs, you can change the
interface-specific and system- and stack-wide settings.
If you do not configure the internal interface at all, it operates with the default settings listed in
This table lists the key software features, their defaults, and where to find more information about the
features.
For information about setting up the initial internal interface configuration (using Express Setup or the
CLI setup program) and assigning basic IP information to the internal interface, see the Catalyst 3750
switch hardware installation guide.
Table 2
Feature
IP address
Domain name
DHCP
Switch stack
Switch cluster
Passwords
TACACS+
RADIUS
System name and prompt
NTP
DNS
802.1x
Port parameters
Operating mode
Interface speed and duplex mode
Auto-MDIX
Flow control
Power-over-Ethernet (PoE)
SmartPorts macros
VLANs
Cisco IOS Release 12.2(25)SEC
42
Default Settings
3
Cisco EtherSwitch Service Modules Feature Guide
Default Setting
None
None
DHCP client enabled
1
DCHP server enabled
DHCP relay agent enabled
Enabled
Disabled
None defined
Disabled
Disabled
Switch
Enabled
Enabled
Disabled
Layer 2 (switchport)
Autonegotiate
Enabled
Off
Autonegotiate
None defined
Table
2
2.